Multi-row bearing
Four-row cylindrical roller bearings are available in several designs:
- with a cylindrical or tapered bore
- open or sealed
Four-row cylindrical roller bearings are used almost exclusively for the roll necks of rolling mill stands, calenders and roller presses. Because they are normally mounted with an interference fit on the roll neck, four-row cylindrical roller bearings are well suited for rolling mill applications where the rolling speed is high.
Because four-row cylindrical roller bearings can accommodate only radial loads, they are mounted together with deep groove or angular contact ball bearings, or with tapered roller bearings (either radial or thrust design) which accommodate the axial loads.
Bearing features
- Exceptional high load carrying capacity
Because of their high number of rollers, four-row cylindrical roller bearings are suitable for very heavy radial loads. - Low friction (Roller end / flange contact area)
The open flange design, together with the roller end design and surface finish, promote lubricant film formation resulting in lower friction. - Long service life
The logarithmic roller profile reduces edge stresses at the roller/raceway contact and sensitivity to misalignment and shaft deflection. - Enhanced operational reliability
The surface finish on the contact surfaces of the rollers and raceways supports the formation of a hydrodynamic lubricant film. - Separable and interchangeable
The separable components of SKF four-row cylindrical roller bearings are interchangeable. This facilitates mounting and dismounting, as well as maintenance inspections. - High speed capability
The cage designs are suitable for high speeds, rapid accelerations and peak loads. - Low cross-sectional height
The low cross-sectional height of four-row cylindrical roller bearings allows for relatively large roll neck diameters compared to the roll diameter.
- MEYLE Wheel Bearing Kit 100 650 0008
- 1 pcs
- Negotiable
- SWAG Wheel Bearing Kit 40 90 1971
- 1 pcs
- Negotiable
- Timken 228410 Rear Main Bearing Seal
- 1 pcs
- Negotiable
- FEBI BILSTEIN Tensioner Pulley, timing belt 06880
- 1 pcs
- Negotiable
- MEYLE Wheel Bearing Kit 37-14 650 0007
- 1 pcs
- Negotiable
- OPTIMAL Wheel Bearing Kit 702850
- 1 pcs
- Negotiable
- SWAG Bearing Set, axle beam 10 79 0014
- 1 pcs
- Negotiable
- OPTIMAL Wheel Bearing Kit 102011
- 1 pcs
- Negotiable
- A.B.S. Wheel Bearing Kit 200011
- 1 pcs
- Negotiable
- MEYLE Wheel Bearing Kit 614 750 0012
- 1 pcs
- Negotiable